Metal Trunking Splice and End Fittings

Metal trunking splice and end fittings consist of splice parts that join lengths of sheet metal cable trunking end to end, reducer plates that complete the point where the trunking width changes, dividers that partition the inside of the trunking, and parts that terminate the end of the run. They are used at the joint where a straight run is extended, at the point where the run steps down to narrower trunking, and where power and low-current cables in the same trunking must be kept apart. This category includes UKS reducer plates in 40, 60 and 100 mm heights, trunking splice elements and dividers, and the splice and end fittings for the underfloor trunking system, with pre-galvanized or hot-dip galvanized coatings. Choose the part according to the side height and width of the trunking, or the width difference between two trunkings, the sheet thickness and the coating type; verify the trunking system it belongs to from the stock code. Splice and end fittings whose stock code contains DEK and DS are for underfloor trunking; lengths of suspended perforated cable trunking are not joined with these but with the trunking splice element.

Products

How to choose Metal Trunking Splice and End Fittings

Metal trunking splice and end fittings consist of splice parts that join lengths of sheet metal cable trunking end to end, reducer plates that complete the point where the trunking width changes, dividers that partition the inside of the trunking, and parts that terminate the end of the run. They are used at the joint where a straight run is extended, at the point where the run steps down to narrower trunking, and where power and low-current cables in the same trunking must be kept apart.

  • Clarify whether the task is connection, cable routing, enclosure distribution or termination.
  • Match dimensions, thread standard, conductor cross-section and IP rating with the cable and panel.
  • Choose housing material and pack quantity according to the mounting environment.

Frequently asked questions

What is Metal Trunking Splice and End Fittings and where is it used?

Metal trunking splice and end fittings consist of splice parts that join lengths of sheet metal cable trunking end to end, reducer plates that complete the point where the trunking width changes, dividers that partition the inside of the trunking, and parts that terminate the end of the run. They are used at the joint where a straight run is extended, at the point where the run steps down to narrower trunking, and where power and low-current cables in the same trunking must be kept apart.

What should I compare when choosing Metal Trunking Splice and End Fittings?

Choose the part according to the side height and width of the trunking, or the width difference between two trunkings, the sheet thickness and the coating type; verify the trunking system it belongs to from the stock code.

Where can I find technical details for Metal Trunking Splice and End Fittings products?

Splice and end fittings whose stock code contains DEK and DS are for underfloor trunking; lengths of suspended perforated cable trunking are not joined with these but with the trunking splice element.

Metal Trunking Splice and End Fittings Selection Guide: Technical Criteria and Engineering Practice